From the custom plastic bottle maker to the gallon plastic jugs, the process of plastic manufacturing – and the distribution of said plastic – is not only important here in the United States but in all parts of the world as well. And the plastics industry itself is thriving, as is more than backed up by the data that has recently been gathered on the subject. In fact, the industry of plastics alone provides up to three hundred and seventy five billion dollars to the economy on a yearly basis, in a period of a mere twelve months, if that.
And job creation in the world of plastic manufacturing is also nothing if not impressive, with currently more than one million people employed in the industry all throughout the United States. This is nothing more than a necessity, as this country represents the third largest country for the manufacturing of plastic in the entirety of the world. In the year of 2013 alone, for instance, more than one hundred and seven billion pounds of plastic and other such resins were manufactured. In the years that have passed by since, the need for the custom plastic bottle maker and plastic bottle packaging and all other facets of plastics manufacturing has only continued to grow and increase on a truly exponential basis.
Much of this is due to the fact that there is a high demand for plastic all over the world – but this high demand can particularly be seen here in the United States. In fact, plastic water bottles alone (as any custom plastic bottle maker will know) are highly used. The statistics and recently gathered data even show that as many as two and a half million water bottles are used and then discarded in the very small time span of just one single hour. And that’s not a statistic that represents the entirety of the world but one that impacts just the United States itself.
In a year, the world as a whole will consume only that amount of water bottles but up to six billion pounds of plastic. And this is certainly not a stagnant number. In fact, it is anything but, with the market for plastic increasing by a steady rate of at least five percent for each and every year that passes us by.
Unfortunately, many people are concerned about using too much plastic. After all, there is a growing problem with waste creation not only here in this country of the United States but truly in the vast majority of places all around the world – and it is a problem that has become so relevant and so prevalent that it is simply impossible to deny. However, the impact of plastic is what you make of it, and recycling any plastic that you consume is just one way to ethically consume plastic not only here in the United States but all around the world as well.
The custom plastic bottle maker can also used recycled materials in the creation of said custom plastic bottles or other such custom plastic containers. In fact, the average custom plastic bottle maker might even find this method of reusing and therefore reducing waste to even be quite cost effective in the long run (as well as in the short term, in many cases). So not only does is recycling good for the planet but it’s often also beneficial from a financial standpoint as well.
Of course, the effectiveness of plastic must also be discussed. Fortunately, a little amount of plastic goes further than many people would think, as the custom plastic bottle maker would easily be able to tell you. The amount of plastic used to make a plastic water bottle is far less than the amount of other materials, such as glass or aluminum, that would be needed for the very same purpose. In fact, a mere two pounds of plastic can deliver up to ten gallons of various liquids, while up to three pounds of aluminum would be needed – and an astounding forty pounds of glass – would be needed for the same purpose and end result.